常問問題 FAQ (Frequently Asked Questions)
FAQ (Frequently Asked Questions)
To find answers to your questions, select the category.
By-alarm anti-intrusion
1 The connector art.20478/19478/14478 continues to trigger a "tamper"alarm on the system
If enabled, check that the mechanical contact, positioned at the rear of the product (inside the box), is correctly closed.
If the mechanical tamper is not used, disable the function using the “Connectors programming” procedure indicated in the product instruction sheet.
2Two connectors art.20478/19478/14478 are mounted in the system but the secong one is not recognised by the control panel even
The system will not permit the configuration of more than one connector with the same address or with addresses other than 1 to 8.
Check that you have correctly completed the address assignment procedure “Connector addressing” indicated in the product instruction sheet.
Warning: the procedure is similar to the “Parameter configuration” procedure, the difference lies in the different switch on sequence of the device LEDs.
Check that you have correctly completed the address assignment procedure “Connector addressing” indicated in the product instruction sheet.
Warning: the procedure is similar to the “Parameter configuration” procedure, the difference lies in the different switch on sequence of the device LEDs.
3Can I associate a connector art.20478/19478/14478 to different areas?
Yes. With this configuration it is not possible to manage INT, PAR activations.
The connector will only set ON and deactivate the areas for which it is enabled.
Remember that in this specific case the connector cannot be associated to a user without “Turn on in ON” permission.
The connector will only set ON and deactivate the areas for which it is enabled.
Remember that in this specific case the connector cannot be associated to a user without “Turn on in ON” permission.